APC AP9890 – Rack Power Cord Kit IEC C13–C14 0.6 m (5 Pack)

Overview :

The APC AP9890 is a set of five standardized IEC power jumper cords intended for linking rack‑mount power distribution units (PDUs) to IT equipment with IEC input receptacles. Data center infrastructure engineers and rack technicians deploy this kit in cabinet environments that require multiple short power interconnects for servers, storage, and networking devices.

Each cord provides a male IEC 60320 C14 plug on the PDU end and a female IEC 60320 C13 connector on the equipment end. The 0.6 m (2 ft) length supports orderly horizontal routing within standard 19‑inch racks, reduces excess slack, and aligns with typical rack depths.

Rated for the common IT voltage range and currents up to 10 A, AP9890 cords are suitable for use with PDUs and devices supporting IEC‑rated power connections. This aligns with standard branch‑circuit power distribution schemes in enterprise and colocation environments.

The kit addresses the operational need for consistent, interchangeable power jumpers across multiple racks or cabinets. It is best deployed where multiple short IEC power cords are required from rack‑mount PDUs to adjacent equipment outlets.

This product is not a replacement for building mains feeds or non‑IEC systems. Avoid use in infrastructures lacking IEC standard receptacles or where longer reach power cabling is required. 

Key Features :

• Five IEC 60320 C14 to C13 power jumper cables
• 0.6 m (2 ft) length for short rack runs
• 10 A rated for standard IT loads
• Black jacket for cable management consistency
• Standardized connectors for PDU/equipment match

Specifications :