APC Back UPS 850VA with 2 USB Charging Ports - 850 VA Standby UPS
Overview
The APC BE850G2 is a standby uninterruptible power supply (UPS) that provides temporary battery backup and surge protection for electronics, networking equipment, and small servers during utility power disruptions. It is used by IT support teams, small business administrators, and home office operators to sustain critical loads during brief outages and help prevent data loss or hardware disruptions.
This UPS delivers 850 VA / 450 W of capacity and switches to battery power when input voltage deviates outside acceptable thresholds. It uses standby topology with a stepped approximation to a sine wave output and typical transfer times of about 6 ms to maintain continuity for protected loads.
Outlets are organized to separate battery-backup plus surge protection from surge-only receptacles, enabling critical circuits to receive runtime support while protecting non-critical circuits from surges without draining battery reserve. Two USB Type-A charging ports provide auxiliary 5 V DC output for mobile device charging without drawing from UPS runtime capacity.
The internal sealed lead-acid battery is maintenance-free and automatically recharges when utility power is restored. Typical recharge time after a full discharge cycle is approximately 8 hours, and serviceable replacement batteries are supported to extend the unit's service life.
The compact tower form factor allows placement beside equipment racks, desks, or shelves where space is constrained. Integrated LED indicators and audible alarms communicate utility status, battery mode, and fault conditions to operators managing equipment tied to the UPS.
This unit does not generate power independently and must remain connected to mains AC to maintain battery charge and provide regulated output to connected loads.
Key Features
• 850 VA / 450 W standby UPS with fast automatic transfer
• 6 battery-backup + surge outlets, 3 surge-only outlets
• Two USB Type-A charging ports for auxiliary devices
• Maintenance-free sealed lead-acid battery with ~8 h recharge
• LED status indicators and audible alarms for power events
Specifications
| Specification | Detail |
|---|
| Brand | APC by Schneider Electric |
| Part Number | BE850G2 |
| Product Type | Standby UPS Battery Backup |
| Rated Capacity | 850 VA / 450 W |
| Topology | Standby (offline) |
| Output Waveform | Stepped approximation to sine wave |
| Input Voltage Range | ~92 - 139 V AC |
| Nominal Output Voltage | 120 V AC |
| Frequency | 50 / 60 Hz auto-sensing |
| Outlets | 6× battery backup + surge, 3× surge-only |
| USB Ports | 2× USB Type-A (5 V DC) |
| Transfer Time | ~6 ms typical, up to ~10 ms |
| Surge Energy Rating | ~354 J |
| Battery Type | Sealed lead-acid, maintenance-free |
| Typical Half-Load Runtime | ~11 minutes |
| Typical Full-Load Runtime | ~2.4 minutes |
| Recharge Time | ~8 hours |
| Replacement Battery | RBC17 |
| Operating Temp | 0 - 40 °C |
| Operating Humidity | 0 - 95 % non-condensing |
| Dimensions (WxHxD) | ~12.87 × 5.47 × 4.13 in |
| Weight | ~9.04 lb (4.1 kg) |
